SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISBRAKESANTILOCK BRAKE SYSTEM WITH TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC C0279 (W/O JL4)TEST DESCRIPTION
2006 Chevrolet Suburban C1500, 5.3 Z

Test Description

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Test Description

The number below refers to the step number on the diagnostic table.

  1. 3:  The powertrain control module (PCM) must have the correct part number for the specified application.
DTC C0279 (W/O JL4)

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Use a scan tool in order to clear the DTCs.
  2. Turn OFF the ignition for 5 seconds.
  3. Turn ON the ignition and wait 10 seconds.
Does the DTC set?		 Go to Step 3  Go to Diagnostics Aids
3  Verify the correct powertrain control module (PCM) is installed in the vehicle.
Does the vehicle have the correct PCM?		 Go to Step 4  Go to Step 6 
4 Use the scan tool in order to read the Calibration IDs of the PCM.
Are the PCM Calibration IDs correct?		 Go to Diagnostics Aids Go to Step 5 
5 Perform the set up procedure for the PCM. Refer to Service Programming System (SPS) .
Did you complete the action?		 Go to Step 7  -
6 Replace the PCM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 7  -
7
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.
Does the DTC reset?		 Go to Step 3  System OK
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.