Removal Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Removal Procedure
  1. Raise and support the window glass.
  2. Remove the trim panel. Refer to Trim Panel Replacement - Side Rear Door (Tahoe/Yukon/Escalade)Β  or Trim Panel Replacement - Side Rear Door (Suburban/Yukon XL/Avalanche/Escalade EXT)Β .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Tahoe/Yukon/Escalade)Β  or Water Deflector Replacement - Rear Door (Suburban/Yukon XL/Avalanche/Escalade EXT)Β .
  4. Disconnect the window motor electrical connector.
  5. Loosen the two window clamp bolts on the regulator.
  6. Remove the bolts retaining the window regulator to the door.
  7. Fig 1: Removing Rear Power Window Module (Tahoe/Yukon/Escalade)
    GM581720Courtesy of GENERAL MOTORS CORP.
  8. Remove the module from the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.