SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEOBJECT DETECTION SYSTEMREPAIR INSTRUCTIONSOBJECT ALARM MODULE REPLACEMENT (CADILLAC EXT)REMOVAL PROCEDURE
2006 Chevrolet Suburban C1500, 5.3 Z

Removal Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Removal Procedure
    Fig 1: Removing Object Alarm Module Cover (Cadillac EXT)
    GM814570Courtesy of GENERAL MOTORS CORP.
  1. Lift the left rear seat cushion up to gain access to the electronic suspension control module and rear object alarm module container.
  2. Remove the cover retainers, discard if damaged.
  3. Partially remove the container assembly from underneath the seat.
  4. Remove the cover (1) by pushing in on the tabs to release the cover.
    5. Fig 2: Disconnecting Electrical Connector From Rear Object Alarm Module (Cadillac EXT)
    GM814571Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector (1) from the rear object alarm module (2).
    6. Fig 3: Removing Object Alarm Module From Container (Cadillac EXT)
    GM1363966Courtesy of GENERAL MOTORS CORP.
  6. Release the tabs retaining the module to the container (2).
  7. Remove the module (1) from the container (2).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.