Removal Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Removal Procedure
  1. Raise and support the window glass.
  2. Remove the trim panel. Refer to Trim Panel Replacement - Side Front Door .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
  4. Disconnect the harness from the electric window motor assembly.
  5. Remove the 2 bolts that hold the window glass to the regulator.
  6. Fig 1: Removing Window Regulator Bolts
    GM348453Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolts from the window regulator.
  8. Remove the window regulator assembly from the door by folding both sides of the window regulator assembly together.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.