SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Suburban C1500, 5.3 Z

Installation Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure
    Fig 1: Disconnecting Lower Electrical Harness Connectors
    GM914892Courtesy of GENERAL MOTORS CORP.
  1. Position the module into the vehicle.
  2. Connect the lower electrical harness connectors (2).
    3. Fig 2: Memory Seat Control Module, Harness Connectors & Screws
    GM914889Courtesy of GENERAL MOTORS CORP.
  3. Slide the module (2) to the left to engage the lower retainers.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the module retaining screws (3).

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

  5. Connect the upper electrical harness connectors (3).
  6. Install the seat cushion. Refer to Seat Cushion Frame Replacement - Front .
  7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.