SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SUBURBAN C1500, 5.3 ZREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMREPAIR INSTRUCTIONSWIPER MOTOR REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Suburban C1500, 5.3 Z

Removal Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Removal Procedure
    Fig 1: Reinforcement Panel Bolts
    GM348540Courtesy of GENERAL MOTORS CORP.
  1. Remove the wiper arms. Refer to Wiper Arm Replacement .
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  3. Remove the 4 bolts and the reinforcement panel.
    4. Fig 2: Wiper Motor Electrical Connector
    GM348725Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector from the wiper motor.
    5. Fig 3: Wiper Transmission Assembly
    GM348543Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 bolts from the wiper transmission assembly.
  6. Remove the wiper transmission assembly from the vehicle.
    7. Fig 4: Disconnecting Wiper Transmission From Wiper Motor Crank Arm
    GM306506Courtesy of GENERAL MOTORS CORP.
  7. Remove the drive link from the wiper motor crank arm with the J 39232  . See Special Tools .
    8. Fig 5: Removing Wiper Motor
    GM513716Courtesy of GENERAL MOTORS CORP.
  8. Remove the 2 bolts retaining the wiper motor.
  9. Remove the wiper motor from the wiper transmission assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.