Installation Procedure

2006 Chevrolet Suburban C1500, 5.3 ZSECTION Installation Procedure
    Fig 1: Removing Object Alarm Module From Container (Cadillac EXT)
    GM1363966Courtesy of GENERAL MOTORS CORP.
  1. Install the module (1) to the container (2).
  2. Fig 2: Disconnecting Electrical Connector From Rear Object Alarm Module (Cadillac EXT)
    GM814571Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (1) to the module (2).
  4. Fig 3: Removing Object Alarm Module Cover (Cadillac EXT)
    GM814570Courtesy of GENERAL MOTORS CORP.
  5. Install the container cover (1) and lock in place.
  6. Slid the container under the rear seat.
  7. Install the container retainers.
  8. Set the rear seat to its original position.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.