Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSHORN SWITCH REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet SSR Automatic

Installation Procedure

2006 Chevrolet SSR AutomaticSECTION Installation Procedure

Fig 1: View of Horn Contact Plate, Steering Wheel & Screws

Courtesy of GENERAL MOTORS CORP.

Install the horn switch (2) to the steering wheel (3).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Connect the screws (1,4) that secure the contact plate to the steering wheel (3).
Tighten: Tighten the screws to 5.5 N.m (49 lb in).

Fig 2: View Of Horn Plunger At Steering Column

Courtesy of GENERAL MOTORS CORP.

Install the horn plunger to the steering column.
Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.