SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMREPAIR INSTRUCTIONSSIR DISABLING AND ENABLING ZONE 9ENABLING PROCEDURE
2006 Chevrolet SSR Automatic

Enabling Procedure

2006 Chevrolet SSR AutomaticSECTION Enabling Procedure
  1. Remove the key from the ignition.
    2. Fig 1: Identifying CPA Clip
    GM869639Courtesy of GENERAL MOTORS CORP.
  2. Connect the RF side impact module yellow 2-way connector (1) located under the passenger seat.
  3. Install the CPA to the RF side impact module yellow 2-way connector (1) located under the passenger seat.
    4. Fig 2: View Of SIR Fuse In Fuse Box
    GM1370246Courtesy of GENERAL MOTORS CORP.
  4. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
  5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG indicator will then turn OFF.
  6. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.