Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Chevrolet SSR AutomaticSECTION Installation Procedure
- Position the inflatable restraint module to the steering wheel.
- Connect the electrical connectors (1) to the inflatable restraint steering wheel module.
- Connect the CPA retainers into the electrical connectors. Seat and lock the connections.
- Position the alignment posts of the inflatable restraint module to the holes that are located on the steering wheel housing.
- Push the inflatable restraint module into the steering wheel in order to engage and in order to latch the 2 leaf spring fasteners (1).
- After installation, pull the sides of the inflatable restraint module in order to ensure that both leaf spring fasteners are engaged.
- Enable the inflatable restraint steering wheel module. Refer to SIR Disabling and Enabling Zone 3 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.