Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Chevrolet SSR AutomaticSECTION Installation Procedure
- Remove any dirt, grease, or other impurities from the mounting surface.
- Position the side impact sensor (2) horizontally to the door.
- Connect the electrical connector (1) to the side impact sensor (2).
- Install the screws which retain the side impact sensor to the door.
Tighten: Tighten the screws to 8 N.m (71 lb in).
- Fully seat the water deflector to the door.
- Install the door trim panel. Refer to Trim Panel Replacement - Door in Doors.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 and SIR Disabling and Enabling Zone 6 .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.