Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2006 Chevrolet SSR AutomaticSECTION Installation Procedure
- Remove any dirt, grease, etc. from the mounting surface.
- Install the SDM to the vehicle.
- Connect the electrical connection to the SDM.
- Rotate the locking arm (1) to lock the electrical connector to the SDM.
- Install the CPA (1) to the SDM.
- Install the nuts that retain the SDM to the floor panel.
Tighten: Tighten the nuts to 12 N.m (106 lb in).
- Install the floor console. Refer to Console Replacement in Instrument Panel, Gages and Console.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8 .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
IMPORTANT:
The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring that the SDM part number to be setup in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow steps thoroughly to ensure that the SDM is setup properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.