Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2006 Chevrolet SSR AutomaticSECTION Removal Procedure
- Remove the seat from the vehicle. Refer to Seat Replacement in Seats.
- Ensure that the seat is in the full forward position.
- Locate the seat position switch (3) under the seat on the inside of the inner seat rail.
- Disconnect the electrical connector (1) from the seat position switch (3).
- Remove the 2 nuts (2) that retain the seat position switch to the seat rail.
- Remove the seat position switch from the seat.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.