Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2006 Chevrolet SSR AutomaticSECTION Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the rear battery cover bolts (1) and cover (2).
- Disconnect the negative and positive battery cables. Refer to Battery Negative Cable Disconnect/Connect Procedure .
- Remove the positive battery cable from wire loom on top of right side frame rail.
- Lower the vehicle.
- Open the hood.
- Remove the nut retaining the positive battery cable at the junction box.
- Remove the positive battery cable from wire looms under hood.
- Raise the vehicle.
- Remove the positive battery cable from vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.