Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2006 Chevrolet SSR AutomaticSECTION Removal Procedure
- Remove the left and right sunshades. Refer to Sunshade Replacement in Interior Trim.
- Remove the windshield upper garnish molding. Refer to cell Windshield Upper Garnish Molding Replacement in Interior Trim.
- Remove the left and right windshield pillar garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
- Remove the center instrument panel (I/P) trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center .
- Remove the 2 screws retaining the trim plate to the I/P.
- Use a flat-bladed plastic tool to release the retaining clips.
- Remove the ambient light sensor. Refer to Ambient Light Sensor Replacement in Lighting Systems.
- Remove the I/P trim plate from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.