Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLEREPAIR INSTRUCTIONSCONSOLE REPLACEMENTREMOVAL PROCEDURE

2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure

Remove the console upper trim plate. Refer to Trim Plate Replacement - Console Upper .

Fig 1: Identifying Screws Near Body Control Module

GM1195800

Courtesy of GENERAL MOTORS CORP.

Remove the upper 2 screws located near the body control module.
Move the gearshift into the PARK position.
Position the park brake lever to the full UP position.

Fig 2: Identifying Console Front Retaining Tabs

GM1174608

Courtesy of GENERAL MOTORS CORP.

Hold the console and move forward of vehicle to release the front retaining tabs (1).

Fig 3: View of Rear Console

GM1174591

Courtesy of GENERAL MOTORS CORP.

Lift up on the rear of the console and remove from the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.