Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLEREPAIR INSTRUCTIONSCONSOLE REPLACEMENTINSTALLATION PROCEDURE

2006 Chevrolet SSR Automatic

Installation Procedure

2006 Chevrolet SSR AutomaticSECTION Installation Procedure

Fig 1: View of Rear Console

Courtesy of GENERAL MOTORS CORP.

Lift up on the rear of the console and install into the vehicle.

Fig 2: Identifying Console Front Retaining Tabs

Courtesy of GENERAL MOTORS CORP.

Hold the console and move rearward of vehicle to engage the front retaining tabs (1).
Position the park brake lever to the full DOWN position.
Move the gearshift into the LOW position.

Fig 3: Identifying Screws Near Body Control Module

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.