SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBRAKESPARKING BRAKE SYSTEMREPAIR INSTRUCTIONSPARK BRAKE LEVER ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure
    Fig 1: Identifying Park Brake Switch Electrical Connector
    GM1270841Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake if applied.
  2. Remove the center console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  3. Disable the park brake automatic adjuster. Refer to Disabling the Park Brake Cable Automatic Adjuster .
  4. Remove the electrical connector for the park brake switch.
    5. Fig 2: Identifying Park Brake Handle Mounting Nuts
    GM1336383Courtesy of GENERAL MOTORS CORP.
  5. Remove the mounting nuts for the park brake handle.
  6. Remove the park brake handle assembly.
    7. Fig 3: View of Park Brake Handle
    GM1270843Courtesy of GENERAL MOTORS CORP.
  7. Remove the front park brake cable from the park brake handle.
  8. Remove the park brake handle from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.