SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBRAKESPARKING BRAKE SYSTEMREPAIR INSTRUCTIONSPARK BRAKE LEVER ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet SSR Automatic

Installation Procedure

2006 Chevrolet SSR AutomaticSECTION Installation Procedure
    Fig 1: View of Park Brake Handle
    GM1270843Courtesy of GENERAL MOTORS CORP.
  1. Install the front park brake cable.
  2. Install the front park brake cable.
    3. Fig 2: Identifying Park Brake Handle Mounting Nuts
    GM1336383Courtesy of GENERAL MOTORS CORP.
  3. Position the park brake handle on the mounting studs.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the mounting bolts.

    Tighten:  Tighten the mounting bolts to 25 N.m (18 lb ft).

    5. Fig 3: Identifying Park Brake Switch Electrical Connector
    GM1270841Courtesy of GENERAL MOTORS CORP.
  5. Install the electrical connector for the park brake switch.
  6. Enable the park brake cable automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster .
  7. Install the center console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  8. Check operation of the park brake handle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.