Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSWINDOW HEIGHT ADJUSTMENT - DOOR MINOR
2006 Chevrolet SSR Automatic
Window Height Adjustment - Door Minor
2006 Chevrolet SSR AutomaticSECTION Window Height Adjustment - Door Minor
IMPORTANT:
Use this procedure when window height is off less than 3 mm (0.12 in).
- Open the door and remove the door trim panel. Refer to Trim Panel Replacement - Door .
- Lower the window.
- Adjust the front and rear window regulator up stops equally.
- Close the door.
- Raise the window fully and inspect for alignment.
- Lower the window.
- Install the door trim panel. Refer to Trim Panel Replacement - Door .
- Raise the window.
- Close the door.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.