SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSTRIM PANEL REPLACEMENT - DOORREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure
    Fig 1: View of Door Lock Knob
    GM1335817Courtesy of GENERAL MOTORS CORP.
  1. Remove the door lock knob (1) by turning it counterclockwise.
    2. Fig 2: View of Door Handle Bezel
    GM1276297Courtesy of GENERAL MOTORS CORP.
  2. Using a flat-bladed plastic tool and gently pry to remove the door handle bezel.
    3. Fig 3: Identifying Pull Handle Bezel Fastener
    GM1276286Courtesy of GENERAL MOTORS CORP.
  3. Remove the pull handle bezel fastener.
    4. Fig 4: View of Pull Handle Bezel
    GM1150212Courtesy of GENERAL MOTORS CORP.
  4. Remove the pull handle bezel.
    5. Fig 5: View of Door Trim Panel to Door Fasteners
    GM1276282Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 fasteners that retain the door trim panel to the door.
  6. Use the J 38778  to release the plastic retainers around the door trim panel.
    7. Fig 6: View of Door Trim Panel
    GM1150264Courtesy of GENERAL MOTORS CORP.
  7. Lift up on the door trim panel to disengage the door trim panel clips to the door structure.
    8. Fig 7: View of Electrical Connector
    GM1335827Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the electrical connector.
  9. Remove the door trim panel from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.