Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure
    Fig 1: View of Door Handle Bezel
    GM1326416Courtesy of GENERAL MOTORS CORP.
  1. Remove the door handle bezel. Refer to Door Handle Bezel ReplacementΒ .
  2. Fig 2: View of Door Pull Handle
    GM1326417Courtesy of GENERAL MOTORS CORP.
  3. Remove the door pull handle. Refer to Pull Handle ReplacementΒ .
  4. Remove the door trim panel. Refer to Trim Panel Replacement - DoorΒ .
  5. Fig 3: View Of Inner Door Panel Protector
    GM1275116Courtesy of GENERAL MOTORS CORP.
  6. Remove the water deflector. Refer to Water Deflector Replacement - Front DoorΒ .
  7. Fig 4: Expanded View of Door Handle
    GM1326421Courtesy of GENERAL MOTORS CORP.
  8. Using a flat-bladed tool, release the door handle from the door.
  9. Fig 5: Expanded View of Inside Door Handle Linkage
    GM1326419Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the inside door handle linkage from the door latch.
  11. Fig 6: Identifying Inside Door Handle
    GM1326423Courtesy of GENERAL MOTORS CORP.
  12. Remove the inside door handle from the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.