Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSDOOR ADJUSTMENTIN/OUT ADJUSTMENT PROCEDURE
2006 Chevrolet SSR Automatic
In/Out Adjustment Procedure
2006 Chevrolet SSR AutomaticSECTION In/Out Adjustment Procedure
IMPORTANT:
Loosen 1 set of door hinge bolts at a time and move the door hinge not the door be sure to retighten the door hinge bolts before loosing and adjusting the other door hinge.
- Loosen the upper door hinge to door bolts.
- Reposition the door hinge outward to adjust the door inward or inward to adjust the door outward.
- Tighten the upper door hinge to door bolts.
Tighten: Tighten the door hinge to door bolts to 25 N.m (18 lb in).
- Loosen the lower door hinge to door bolts.
- Reposition the door hinge.
- Tighten the lower door hinge to door bolts.
Tighten: Tighten the door hinge to door bolts to 25 N.m (18 lb in).
- Repeat procedure for additional adjustment, if necessary.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.