SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet SSR Automatic

Installation Procedure

2006 Chevrolet SSR AutomaticSECTION Installation Procedure
    Fig 1: Identifying Front Seat Mount Nuts
    GM1150156Courtesy of GENERAL MOTORS CORP.
  1. Install the seat to the vehicle.
  2. Connect the electrical harness. Clip the harness to the seat bracket.
  3. Connect the yellow SIR electrical connector.
  4. Connect the seat belt buckle electrical connector.
  5. Install the front seat mounting bolt. Do not tighten.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the 3 front seat mounting nuts on the floor studs.

    Tighten: 

    • Tighten the front seat mounting nuts to 45 N.m (33 lb ft).
    • Tighten the front seat mounting bolt to 45 N.m (33 lb ft).

  7. Feed the seat belt through the seat guide loop and install the seat belt anchor bolt. Refer to Seat Belt Replacement - Front in Seat Belts.
  8. Enable the SIR. Refer to SIR Disabling and Enabling Zone 7 and to SIR Disabling and Enabling Zone 9 in SIR.
  9. Install the seat mounting fastener covers.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.