Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSLUMBAR REPLACEMENT - FRONT SEATREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic
Removal Procedure
2006 Chevrolet SSR AutomaticSECTION Removal Procedure
- Remove the seat from the vehicle. Refer to Seat Replacement .
- Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
- Remove the seat back panel. Refer to Seat Back Panel Replacement - Front .
- Disconnect the electrical connector from the lumbar motor.
- Detach the seat back frame wire (2) from the top of the lumbar (1).
- Detach the seat back frame wire from the bottom of the lumbar.
- Drill out and remove the 2 lumbar motor mounting rivets (1).
- Remove the lumbar assembly (2) from the seat.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.