Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSLUMBAR REPLACEMENT - FRONT SEATINSTALLATION PROCEDURE

2006 Chevrolet SSR Automatic

Installation Procedure

2006 Chevrolet SSR AutomaticSECTION Installation Procedure

Fig 1: Identifying Lumbar Motor Mounting Rivets & Lumbar Assembly

Courtesy of GENERAL MOTORS CORP.

Position the lumbar assembly (2) onto the seat.
Install the lumbar motor to the seat frame with 2 new rivets (1).

Fig 2: Identifying Seat Back Frame Wire & Lumbar

Courtesy of GENERAL MOTORS CORP.

Attach the top and bottom of the lumbar (1) onto the seat back frame wire (2).
Connect the electrical connector to the lumbar motor.
Install the seat back panel. Refer to Seat Back Panel Replacement - Front .
Install the seat back pad and cover. Refer to Seat Back Cover and Pad Replacement - Front .
Install the seat in the vehicle. Refer to Seat Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.