Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSHEATED SEAT SWITCH REPLACEMENT - FRONTREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic
Removal Procedure
2006 Chevrolet SSR AutomaticSECTION Removal Procedure
- Remove the seat cushion outer trim panel from the seat assembly. Refer to Seat Cushion Outer Trim Panel Replacement .
- Remove the seat switch bezel. Refer to Seat Switch Bezel Replacement .
- Release the tabs (1) that retain the heated seat switch (2) to the seat switch bezel (3).
- Disconnect the electrical connector on the heated seat switch harness from the seat wiring harness.
- Remove the heated seat switch from the seat switch bezel assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.