Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINTERIOR TRIMREPAIR INSTRUCTIONSFLOOR CARPET DRYING
2006 Chevrolet SSR Automatic
Floor Carpet Drying
2006 Chevrolet SSR AutomaticSECTION Floor Carpet Drying
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components:
- For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly.
- For a 2-piece carpet assembly with a cotton or a fiber padding, replace the padding only. While the carpet is out of the vehicle, dry the carpet using the method described below.
- For a 1-piece carpet assembly bonded to a foam padding or attached to a synthetic padding, dry the carpet using the method described below.
- For a 2-piece carpet assembly with a synthetic padding, dry the assembly using the method described below.
Drying Method
- If you observe puddles of liquid on the carpet face, use a wet vacuum to remove the excess moisture.
- Blot the face of the carpet with a towel in order to absorb as much moisture as possible.
- Point a fan at the affected area and air dry the carpet.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.