Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENTNOTES
2006 Chevrolet SSR Automatic
High Mounted Stop Lamp Replacement: Notes
2006 Chevrolet SSR AutomaticSECTION Notes
Tools Required
- J 25070 Heat Gun
- Varnish Makers and Painters (VMP) Naptha
- Plastic Flat-Bladed Tool - Deburr any sharp or rough edges on the plastic tool to prevent scratching of the paint finish.
IMPORTANT:
- Maintain body surfaces and adhesive tapes between 21-38°C (70-100°F) during installation.
- Never apply adhesive tapes when the body surface and tape is below 21°C (70°F).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.