SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTENTERTAINMENT SYSTEMSREPAIR INSTRUCTIONSANTENNA CABLE REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure
    Fig 1: View of Right Hinge Pillar Trim
    GM1335119Courtesy of GENERAL MOTORS CORP.
  1. Remove the right hinge pillar trim. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
    2. Fig 2: View of Windshield Pillar Trim Panel
    GM1337974Courtesy of GENERAL MOTORS CORP.
  2. Remove the windshield pillar trim panel. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
    3. Fig 3: View of Coax Cable Connector
    GM1337981Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the coax cable connector.
    4. Fig 4: View of Antenna Module
    GM1337886Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper windshield garnish molding. Refer to Windshield Upper Garnish Molding Replacement in Interior Trim.
  5. Disconnect the coax cable from the antenna module.
  6. Remove the coax cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.