SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTENTERTAINMENT SYSTEMSREPAIR INSTRUCTIONSAMPLIFIER REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure
    Fig 1: View of Folding Top
    GM1362522Courtesy of GENERAL MOTORS CORP.
  1. Cycle the folding top to reveal the body rear accessory compartment.
  2. Turn the ignition switch to the OFF position.
    3. Fig 2: Identifying Body Accessory Compartment Lid Nuts
    GM1386454Courtesy of GENERAL MOTORS CORP.
  3. Loosen the nuts and remove the lid from the body accessory compartment.
  4. Remove the folding top control module. Refer to Folding Top Control Module Replacement in Roof.
  5. Remove the rear relay center. Refer to Rear Electrical Center or Junction Block Replacement in Wiring Systems.
  6. Remove the daytime running lamps (DRL) diode. Refer to Daytime Running Lamps (DRL) Diode Replacement in Lighting Systems.
    7. Fig 3: View of Intermediate Bracket Fasteners
    GM1344058Courtesy of GENERAL MOTORS CORP.
  7. Remove the 4 fasteners retaining the intermediate bracket.
    8. Fig 4: Identifying Amplifier Electrical Connectors & Fasteners
    GM1344086Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the electrical connectors to the amplifier (3).
  9. Remove the 4 fasteners (1, 2) retaining the amplifier to the body rear accessory compartment.
  10. Remove the amplifier from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.