Radio/Audio System Description and Operation: Notes

2006 Chevrolet SSR AutomaticSECTION Notes

The entertainment system on this vehicle is configured with a radio, antenna, and speakers.

The following list shows the radios available for this vehicle:

  • Base Radio (UB0) - AM/FM with CD
  • Uplevel Radio (UC6) - AM/FM, Integral Multi Disc CD Changer
Radio Features

Controls UB0 UC6
Power Push PWR/VOL knob to turn the radio ON
Volume The volume is adjusted by rotating the PWR/VOL knob
Automatic Volume Control Press the AUTOVOL button
Tune Turn the TUNE knob
Seek Momentarily press SEEK/PSCAN button Momentarily press SEEK/SCAN button
Scan N/A Hold SEEK/SCAN button at least 2 seconds
Preset Scan Hold SEEK/PSCAN button at least 2 seconds N/A
Presets Six AM, Six FM1 and Six FM2
Preset Saving Press and hold desired button until an audible beep is heard
Set Clock Press and hold the HR or MN button until an audible beep indicates the time set mode has been entered. Once the beep is heard, the time can be set by tapping each button to incrementally adjust the time. Holding down each button will rapidly change the time.
Recall Push the TUNE knob
Fade or Balance Press the AUDIO knob to select and turn to adjust
Bass, Treble or Midrange Press the AUDIO knob to select and turn to adjust
Automatic Tone Press AUTO TONE button Press AUTO EQ button
Compact Disc Features

Controls UB0 Radio UC6 Radio
Eject Press the EJT button Press the eject button
Fast Forward Press the preset 4 button Press the FWD button
Reverse Press the preset 3 button Press the REV button
Disc Press the preset 5 button N/A
Previous Press the preset 1 button Press the left SEEK/SCAN arrow
Next Press the preset 2 button Press the right SEEK/SCAN arrow
Random Press the preset 6 button Press the RDM button

Each item in the list below represents topics covered in detail below.

  • AM/FM Reception
  • Audio Amplifier
  • Theft Deterrent
  • Integral Multi Disc CD Changer (IMDX)
  • Radio Data System (RDS)
  • Tape/CD Player Error Messages
  • Voice Recorder
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.