SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESCOMPUTER/INTEGRATING SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESRETAINED ACCESSORY POWER (RAP) ON AFTER TIMEOUT
2006 Chevrolet SSR Automatic

Retained Accessory Power (RAP) On After Timeout

2006 Chevrolet SSR AutomaticSECTION Retained Accessory Power (RAP) On After Timeout
Retained Accessory Power (RAP) On After Timeout

Step Action Yes No
Schematic Reference: Body Control System Schematics  and Data Link Connector (DLC) Schematics 
Connector End View Reference: Master Electrical Component List in Wiring Systems
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Observe the following parameters in BCM data list:
    • Driver Door Ajar Sw.
    • Passenger Door Ajar Sw.
  2. Open and close each door while observing the respective parameter.
Does the scan tool display change from On to Off?		 Go to Step 3  Go to Symptoms - Lighting Systems in Lighting Systems
3
  1. Install a scan tool. Select diagnostic circuit check and then class 2 power mode.
  2. Close all the doors.
  3. Turn ON the ignition, with the engine OFF.
  4. Wait 5 seconds then turn the ignition OFF.
  5. Wait the time-out for retained accessory power (RAP).
Did the scan tool display the RAP power mode, then time-out and display Off-Awake power mode?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 4 
4 Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 6  Go to Step 5 
5 Replace the BCM. Refer to Control Module References  for replacement, setup, and programming.
Did you complete the procedure?		 Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 2 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.