Scan Tool Data List

2006 Chevrolet SSR AutomaticSECTION Scan Tool Data List
Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Ignition ON, Engine OFF and Brake released 
4WD Status 4WAL 3 Sensor Two wheel drive/Four wheel drive Varies
ABS Lamp Command 4WAL 3 Sensor On/Off Off
ABS Pump Motor 4WAL 3 Sensor On/Off Off
ABS Relay Command 4WAL 3 Sensor On/Off ON
ABS Stop State
  • 4WAL 3 Sensor
  • Traction Assist
On/Off Off
Brake Switch Status
  • 4WAL 3 Sensor
  • Traction Assist
On/Off Off
Brake Warning Lamp Command 4WAL 3 Sensor On/Off Off
Diff. Pressure/Fluid Level Switch 4WAL 3 Sensor Ok/Low Ok
Delivered Torque Traction Assist % 35%
DRP Active 4WAL 3 Sensor Yes/No No
Left Front Wheel Speed
  • 4WAL 3 Sensor
  • Traction Assist
km/h or mph 5 km/h/3 mph
LF Dump Valve Command 4WAL 3 Sensor On/Off Off
LF Dump Valve Feedback 4WAL 3 Sensor On/Off Off
LF ISO Valve Command 4WAL 3 Sensor On/Off Off
LF ISO Valve Feedback 4WAL 3 Sensor On/Off Off
Low Traction Lamp Command Traction Assist On/Off Off
Rear Dump Valve Command 4WAL 3 Sensor On/Off Off
Rear Dump Valve Feedback 4WAL 3 Sensor On/Off Off
Rear ISO Valve Command 4WAL 3 Sensor On/Off Off
Rear ISO Valve Feedback 4WAL 3 Sensor On/Off Off
Rear Wheel Speed
  • 4WAL 3 Sensor
  • Traction Assist
km/h or mph 5 km/h/3 mph
Requested Torque Traction Assist % 91%
RF Dump Valve Command 4WAL 3 Sensor On/Off Off
RF Dump Valve Feedback 4WAL 3 Sensor On/Off Off
RF ISO Valve Command 4WAL 3 Sensor On/Off Off
RF ISO Valve Feedback 4WAL 3 Sensor On/Off Off
Right Front Wheel Speed
  • 4WAL 3 Sensor
  • Traction Assist
km/h or mph 5 km/h/3 mph
Traction Control Active Traction Assist Yes/No No
Traction Control Enabled Traction Assist Yes/No Varies
Traction Control Equipped Traction Assist Yes/No Yes
Traction Control Slip Traction Assist Yes/No No
Traction Off Lamp Command Traction Assist On/Off Off
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.