Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Up/Down Adjustment Procedure
2006 Chevrolet SSR AutomaticSECTION Up/Down Adjustment Procedure
- Cycle the folding top open.
- Place a protective covering over the interior of the vehicle and quarter panels.
- Remove the front headliner. Refer to Retractable Roof Headliner Front Trim Panel Replacement in Interior Trim.
- Mark the fasteners to the side rail for a starting reference point.
- Cycle the folding top closed.
- Loosen the folding top rear panel fasteners.
- Adjust the panel as necessary.
Tighten: Tighten the fasteners to 25 N.m (18 lb ft).
- Verify that the folding top rear panel is aligned properly.
- Repeat the adjustment procedure as necessary.
- Cycle the folding top open.
- Install the front headliner. Refer to Retractable Roof Headliner Front Trim Panel Replacement in Interior Trim.
- Remove the protective covering.
- Inspect the folding top for proper operation. Refer to Power Folding Top Description and Operation .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.