SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPPOWER ROOF SYSTEMREPAIR INSTRUCTIONSFOLDING TOP CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet SSR Automatic

Installation Procedure

2006 Chevrolet SSR AutomaticSECTION Installation Procedure
    Fig 1: View of Control Module
    GM1302509Courtesy of GENERAL MOTORS CORP.
  1. Install the folding top control module into the vehicle.
    2. Fig 2: Identifying Electrical Connectors
    GM1302510Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connectors to the control module.
    3. Fig 3: View of Control Module Clips
    GM1302507Courtesy of GENERAL MOTORS CORP.
  3. Push down firmly on the control module to seat the folding top control module clip into the body rear compartment.
    4. Fig 4: View of Body Rear Compartment Lid
    GM1302497Courtesy of GENERAL MOTORS CORP.
  4. Install the body rear compartment lid.
    5. Fig 5: Identifying Body Rear Compartment Lid Fasteners
    GM1302294Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.