Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKSTEERING WHEEL & STEERING COLUMNDIAGNOSTIC INFORMATION AND PROCEDURESIGNITION KEY CANNOT TURN OR STICKS IN ANY POSITION
2006 Chevrolet SSR Automatic
Ignition Key Cannot Turn or Sticks in Any Position
2006 Chevrolet SSR AutomaticSECTION Ignition Key Cannot Turn or Sticks in Any Position
Ignition Key Cannot Turn or Sticks in Any Position
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and Operation? | Go to Step 2 | Go to Steering Wheel and Column Description and Operation |
| 2 | Verify that the lock system has a high lock effort. Does the lock system operate normally? |
System OK | Go to Step 3 |
| 3 | Inspect for an incorrect, worn, or damaged key. Is the key incorrect, worn, or damaged? |
Go to Step 7 | Go to Step 4 |
| 4 | Inspect for a faulty lock cylinder. Is the lock cylinder damaged? |
Go to Step 8 | Go to Step 5 |
| 5 | Inspect the ignition lock cylinder case assembly for damage. Is the ignition lock cylinder case assembly damaged? |
Go to Step 9 | Go to Step 6 |
| 6 | Inspect the ignition switch assembly for damage. Is the ignition switch assembly damaged? |
Go to Step 10 | Go to Step 7 |
| 7 | Replace the key. Refer to Key and Lock Cylinder Coding
in General Information. Did you complete the repair? |
Go to Step 11 | - |
| 8 | Replace the lock cylinder. Refer to Ignition Lock Cylinder Replacement . Did you complete the repair? |
Go to Step 11 | - |
| 9 | Replace the ignition lock cylinder case assembly. Refer to Ignition Switch Replacement . Did you complete the repair? |
Go to Step 11 | - |
| 10 | Replace the ignition switch. Refer to Ignition Switch Replacement . Did you complete the repair? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.