Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006SSR AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSLICENSE LAMP REPLACEMENTREMOVAL PROCEDURE

2006 Chevrolet SSR Automatic

Removal Procedure

2006 Chevrolet SSR AutomaticSECTION Removal Procedure

Fig 1: View of License Lamp Socket

Courtesy of GENERAL MOTORS CORP.

From underneath the vehicle, rotate the license lamp socket counterclockwise to disengage the locking tabs.

Fig 2: View of License Lamp Assembly Fasteners

Courtesy of GENERAL MOTORS CORP.

Remove the license lamp socket from the license lamp assembly.
From underneath the vehicle, hold the license lamp assembly in place while loosening the fasteners from the lamp assembly.
Slide the lamp assembly rearward to remove.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.