Removal Procedure

2006 Chevrolet RV Cutaway 6.6 2SECTION Removal Procedure
    Fig 1: Seat Belt Upper Trim Cover Retainers
    GM892061Courtesy of GENERAL MOTORS CORP.
  1. Remove the upper seat belt trim cover retainers (2).
  2. Remove the seat belt trim cover (1)
  3. Fig 2: Upper Seat Belt Guide
    GM158310Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper seat belt guide retaining bolt from the seat belt guide.
  5. Remove the upper seat belt guide from the vehicle.
  6. Remove the body side trim panel. Refer to Trim Panel Replacement - Right Body Side in Interior Trim.
  7. Fig 3: Seat Belt Retractor Retaining Bolt
    GM158314Courtesy of GENERAL MOTORS CORP.
  8. Remove the seat belt retractor retaining bolt from the vehicle.
  9. Remove the seat belt retractor from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.