Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006RV CUTAWAY 6.6 2REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - 6.6L (LLY) - DTC P0016 TO DTC P0342DTC P0116CIRCUIT/SYSTEM TESTING
2006 Chevrolet RV Cutaway 6.6 2
Circuit/System Testing
2006 Chevrolet RV Cutaway 6.6 2SECTION Circuit/System Testing
- Disconnect the ECT sensor.
- Turn ON the ignition, with the engine OFF.
- Measure for the proper voltage range of 4.9-5.2 volts between the ECT signal circuit and a good ground with a DMM.
- If the voltage is less than 4.9 volts, test the ECT sensor signal circuit for a high resistance short to ground or a faulty ECM.
- Remove and test the ECT sensor. Refer to Component Testing.
- If the resistance measurements of the ECT sensor are out of range, replace the sensor.
- If the ECT sensor tests normal and the DTC continues to set, replace the ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.