Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2006 Chevrolet RV Cutaway 6.6 2SECTION Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Place an alignment mark between the rear inner tube (6) and the rear axle pinion yoke.IMPORTANT: The splines of the propshaft are not keyed.
- Place an alignment mark between the outer tube and inner tube.
- Remove the clamps (2, 5) from the propeller shaft boot. Use a side cutter or other suitable tool. Discard the clamps.
- Support the outer shaft (6) with a suitable stand as necessary.
- Remove the bolts (1) and the yoke retainers (2) from the rear axle pinion yoke (4).
- Disconnect the propeller shaft (3) from the rear axle pinion yoke (4).
- Wrap the bearing caps with tape in order to prevent the loss of the needle bearings.
- Slide the rear inner tube (5) out of the outer tube (6) and remove the propeller shaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.