2006 Chevrolet Impala SSFACTORY OEM SERVICE PROCEDURE

Interior Lamp Switch Replacement

WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Interior Lamp Switch
GM1646739Courtesy of GENERAL MOTORS CORP.
Interior Lamp Switch Replacement

Callout Component Name
Fastener Tightening Specifications:Β  Refer to Fastener Tightening SpecificationsΒ .
1 Instrument Panel Outer Air Outlet Assembly Left
Refer to Instrument Panel Outer Air Outlet Replacement - Left Side .
2 Headlamp Switch Assembly
Tip:Β  The instrument panel dimmer switch is an integral part of the headlamp switch and must be replaced as an assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.