Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Chevrolet Impala SSFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Accelerator Pedal Assembly Nut | 9 N.m | 80 lb in |
| Brake Pedal Position Sensor Screw | 2 N.m | 18 lb in |
| Front Fog Lamp Assembly Screws | 2 N.m | 18 lb in |
| Headlamp Capsule Retaining Bolts | 6 N.m | 53 lb in |
| Instrument Panel Door Opening Frame Screw | 2 N.m | 18 lb in |
| License Plate Lamp Retaining Screws | 2 N.m | 18 lb in |
| Rear Auxiliary Tail Lamp Mounting Nuts | 10 N.m | 89 lb in |
| Roof Rail Rear Courtesy and Reading Lamp Screw | 2 N.m | 18 lb in |
| Tail Lamp Retaining Nuts | 6 N.m | 53 lb in |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.