SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CORVETTE BASE, 2D CONVERTIBLE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESREAR DRIVE AXLEREPAIR INSTRUCTIONSDIFFERENTIAL COOLER ADAPTER NUT REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Corvette Base, 2D Convertible, Automatic

Removal Procedure

2006 Chevrolet Corvette Base, 2D Convertible, AutomaticSECTION Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Lower and support the rear of the exhaust system.
  3. Install a drain pan under the vehicle.
    4. Fig 1: Removing The Quick Connect Fitting Retaining Ring From The Quick Connect Fitting
    GM1491407Courtesy of GENERAL MOTORS CORP.
  4. Remove the differential cooler inlet pipe bolt (1).
  5. Using a bent tip screwdriver, remove the quick connect fitting retaining ring (3) from the quick connect fitting (4) and discard the retaining ring.
  6. Remove the differential cooler inlet pipe from the differential nut.
    7. Fig 2: Removing The Differential Cooler Adaptor Nut From The Differential
    GM1504799Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the differential cooler pump inlet pipe from the differential. Refer to Differential Cooler Hose/Pipe Quick Connect Fitting .
  8. Remove the differential cooler adaptor nut from the differential.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.