Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CORVETTE BASE, 2D CONVERTIBLE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPPOWER ROOF SYSTEM
2006 Chevrolet Corvette Base, 2D Convertible, Automatic
Power Roof System
2006 Chevrolet Corvette Base, 2D Convertible, AutomaticSECTION Power Roof System
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Code Index
- Diagnostic Starting Point - Roof
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B1011
- DTC B1291
- DTC B1420
- DTC B3602
- DTC B3666
- DTC B3670
- DTC B3971
- Symptoms - Roof
- DIC Warning Messages - Roof
- Folding Top Stowage Compartment Lid Release Inoperative
- Power Folding Top Inoperative
- Power Folding Top Does Not Open
- Power Folding Top Does Not Close
- Repair Instructions
- Folding Top Cover Lid, Latch, Actuator Replacement
- Folding Top Weatherstrip, Retainer Replacement
- Folding Top No. 1 Bow, Side, Rear Side Rail Replacement
- Folding Top Link Replacement
- Power Folding Top Switch Replacement
- Folding Top Stowage Compartment Lid Switch Replace
- Folding Top Stowage Compartment Lid Striker
- Folding Top - Adding Fluid
- Folding Top Pump with Motor Replacement
- Folding Top Hydraulic System Bleeding Procedure
- Folding Top Adjustment
- Folding Top Replacement (Manual Top)
- Folding Top Replacement (Power Top)
- Weatherstrip-Folding Top Stowage Compartment Lid
- Folding Top Cover Replacement
- Folding Top Roof Bow Replacement
- Folding Top Seal Compression Panel Replacement
- Folding Top Cover Side Tension Cable Replacement
- Folding Top Clock Spring Replacement
- Folding Top Glare Cover Replacement
- Folding Top Stowage Compartment Lid Hinge Replace
- Folding Top Stowage Compartment Lid Struts Replace
- Folding Top Stowage Compartment Lid Protector
- Folding Top Control Module Replacement
- Folding Top Hydraulic Cylinder Replacement
- Folding Top Hydraulic Cylinder Hose Replacement - All
- Folding Top Locating Pin Receiver Position Sensor Switch Replacement - Front
- Power Folding Top Limit Switches Replacements
- Folding Top Compartment Lid Position Sensor Switch Adjustment - Rear
- Roof Lift Off Panel Front Latch Handle Replacement
- Roof Lift Off Panel Rear Latch Replacement
- Roof Lift Off Panel Rear Locator Replacement
- Roof Lift Off Panel Rear Locator Pin Replacement
- Roof Lift Off Panel Rear Latch Striker Replacement
- Roof Lift Off Panel Front Latch Handle Striker
- Roof Lift Off Panel Adjustment
- Roof Lift Off Panel Molding Replacement
- Roof Rear Panel Replacement
- Weatherstrip Replacement - Lift Off Panel
- Weatherstrip Retainer Replacement - Lift Off Panel
- Description and Operation
- Folding Top Manual Operation
- Power Folding Top Description and Operation
- Power Folding Top System Components
- Power and Grounds
- Folding Top Control Switch
- Folding Top Control Module
- Folding Top Cover Latch Actuator
- Folding Top Cover Pull Down Actuator
- Folding Top Position or Limit Switches
- System Operation
- Hydraulic Control
- Pump Motor and Temperature Sensor
- Driver Notification
- Default Operation
- Power Folding Top Manual Operation
- Lift Off Panel Description
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.