Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (ENGINE CONTROLS - 2.2L (L61) - INTRODUCTION (1 OF 2))COMPONENT LOCATORENGINE CONTROLS COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Engine Controls Component Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Engine Controls Component Views
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Evaporative Emission (EVAP) Canister Vent Solenoid Valve |
| 2 | Evaporative Emission (EVAP) Canister |
| 3 | Fuel Tank |
| 4 | Fuel Pump and Sender Assembly |
| 5 | C305 |
| 6 | Fuel Filter |
| 7 | Fuel Tank Pressure (FTP) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Clutch Pedal Position (CCP) Switch (M86) |
| 2 | Clutch Start Switch (M86) |
| 3 | Stop Lamp Switch |
| 4 | Cruise Control Cancel Switch (M86) |
| 5 | Accelerator Pedal Position (APP) Sensor |
| 6 | Floor Pan |
| Callout | Component Name |
|---|---|
| 1 | Backup Lamp Switch (M86) |
| 2 | Engine Coolant Temperature Sensor (ECT) |
| 3 | Heated Oxygen Sensor (HO2S) 1 |
| 4 | Heated Oxygen Sensor (HO2S) 2 Connector |
| Callout | Component Name |
|---|---|
| 1 | Heated Oxygen Sensor (HO2S) 1 |
| 2 | Heated Oxygen Sensor (HO2S) 2 |
| Callout | Component Name |
|---|---|
| 1 | Fuel Injector 1 |
| 2 | Fuel Injector 2 |
| 3 | Fuel Injector 3 |
| 4 | Fuel Injector 4 |
| Callout | Component Name |
|---|---|
| 1 | Manifold Absolute Pressure (MAP) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Engine Coolant Temperature (ECT) Sensor |
| 2 | Engine Block |
| Callout | Component Name |
|---|---|
| 1 | Throttle Actuator Control (TAC) Module |
| 2 | Ignition Control Module (ICM) |
| 3 | Evaporative Emission (EVAP) Canister Purge Solenoid |
| 4 | Engine Oil Pressure (EOP) Switch |
| 5 | Crankshaft Position (CKP) Sensor |
| 6 | Knock Sensor (KS) |
| 7 | Starter |
| 8 | Starter Solenoid |
| Callout | Component Name |
|---|---|
| 1 | Transmission Control Module (TCM) (MN5) |
| 2 | LF Strut Tower |
| 3 | Engine Control Module (ECM) (L61) |
| 4 | Electronic Brake Control Module (EBCM) (JM4/JL9) |
| 5 | Fuse Block - Underhood Bracket |
| Callout | Component Name |
|---|---|
| 1 | Mass Air Flow (MAF)/Inlet Air Temperature (IAT) Sensor |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.