Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 14 (ENGINE CONTROLS - 2.0L - DTC P0351 TO DTC P2138)DIAGNOSTIC INFORMATION & PROCEDURESDTC P060DCIRCUIT/SYSTEM TESTING
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Circuit/System Testing
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Clear the DTCs with the scan tool. Operate the vehicle within the Conditions for Running the DTC or within the conditions that you observed from the Freeze Frame/Failure Records.
- With the ignition ON, use a scan tool to observe the DTCs.
- If DTC P0602 is set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Replace the ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.