Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROLS - 2.0L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSMANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT (TMAP)REMOVAL PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Removal Procedure
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Disconnect the temperature manifold absolute pressure (TMAP) sensor harness connector.
- Remove the TMAP sensor from the intake manifold.IMPORTANT: If the TMAP sensor seal is damaged, the TMAP sensor must be replaced.
- Inspect the seal for damage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.