SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 887 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - I THROUGH K)COMPONENT CONNECTOR END VIEWS - I THROUGH KINFLATABLE RESTRAINT FRONT PASSENGER PRESENCE SYSTEM (PPS) MODULE (AL0)
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Inflatable Restraint Front Passenger Presence System (PPS) Module (AL0)

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Inflatable Restraint Front Passenger Presence System (PPS) Module (AL0)
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Inflatable Restraint Front Passenger Presence System (PPS) Module (AL0)
GM1550231Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Front Passenger Presence System (PPS) Module (AL0)

Pin Wire Circuit Function
1 0.35 TN/BK 723 I/P Module On Indicator Control
2 0.35 PK 353 I/P Module Off Indicator Control
3 - - Not Used
4 0.35 D-BU 913 Passenger Seat Belt Tension Sensor Signal
5 0.35 BK/WH 1250 Ground
6 0.35 PK/WH 916 PPS Signal
7 0.35 D-BU/WH 918 5-Volt Reference
8 - - Not Used
9 0.35 PK 1339 Ignition Voltage
10-13 - - Not Used
14 0.35 YE 914 Low Reference
15 0.35 YE/WH 917 Low Reference
16 0.35 PK/BK 915 5-Volt Reference
17 - - Not Used
18 0.35 PK 5018 Occupant Sensor Serial Data
Connector Part Information 
  • Harness: Seat
  • OEM: 15431682
  • Service: Service by Harness - See Part Catalog
  • Description: 18-Way F Micro-Pack 100W Series, Sealed (BK)
Terminal Part Information 
  • Terminal/Tray: Service with Terminated Lead
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: 12122523/J-35616-6 (BN)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.