Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 86 (GENERAL INFORMATION)INTRODUCTIONKEY AND LOCK CYLINDER CODINGKEY IDENTIFICATION AND USAGECUTTING KEYSNOTES
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Cutting Keys: Notes
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Notes
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
The vehicle's PASS-Key®II resistor code MUST be determined before duplicating or creating an ignition key. Refer to Replacing Keys
in Theft Deterrent to determine the PASS-Key®II resistor code.
- After the mechanical key code has been determined from the code list, perform the following steps:
- Cut a blank key to the proper level (1) of each of the tumbler positions (2).
- Inspect the key operation in the lock cylinder.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.